DIY Shutter Release for your Canon DSLR
Here is a very simple diagram for a DIY Shutter Release for your Canon DSLR. See Chris’s Link in the comments section for Pentax instructions. What you’ll need.
(1) One - 3/32” Stereo Audio Plug (MUST BE STEREO, NOT MONO)
(2) One – Small Toggle Switch
(3) Two – Momentary Switches (SET TO OPEN)
(4) Wire – Small Gauge Insulated wire w/ at least 3 insulated wires within the main outer insulation. (I used 20’ basic telephone wire and only used 3 of the 4 wires in it.) (length depends on how long you would like your shutter release to reach.)
(5) Wire – Small gauge scrap wire, for wiring switches
(6) One – Project housing or Something to mount your switches on
To read the full post visit CLINE&COMPANY
If you enjoyed this post, make sure you subscribe to my RSS feed!
